To fine-tune your filtering configuration in StudentKeeper, administrators have the option to exclude specific IP addresses from being filtered. This is especially useful in scenarios where trusted networks or devices should bypass standard filtering rules. By accessing the Filter Settings and configuring the IP Filter Rules, users can define IP addresses to exclude based on precise criteria. With clear options to set filtering modes, specify IP types, and add descriptions, this process ensures greater control and flexibility over how and where StudentKeeper filtering is applied.
Prerequisites
- Access to Filter Settings
Exclude IP Addresses from Filtering
You can chose to exclude IP addresses from being filtered by StudentKeeper by doing the following steps:
1. Firstly, Click Filter Settings.
2. Click IP Filter Rules.
3. Click Add IP Filter Rule.
4. Make sure the Mode for Addresses NOT listed below is set to Include.
This means that the IP Addresses not listed below will be included in the Filtering. If it is set to Exclude (not recommended), then the it will only filter the IP Addresses you list below.
5. Enter an IP Address and make sure the Prefix length is set to 32 for IPV4 or 128 for IPV6.
6. Select Exclude for the State to exclude it from being filtered. Or you can Select Include if you want to include it in the filtering only when the Mode for Addresses NOT listed below is set to Exclude.
7. Enter a Comment/Description.
8. Click Save.
Comments
0 comments
Article is closed for comments.